HOW TO CHANGE MY SPORTDOG® YARDTRAINER 350 COLLAR BATTERY

Remove the screws from the front of the collar with a #1 Phillips screwdriver. Then remove the cover.

If you purchased a battery replacement kit from our website, a Phillips screwdriver is provided in the kit.

Pull the front and the back of the collar apart at the seam allowing the strap to slide through the side slots.

Pinch the wires firmly between two fingers. With the other hand, press one finger against the collar.

Carefully pull the battery’s wire plug out of the connector in the collar.

If it doesn’t initially come out, pull harder.

Remove the rubber gasket from the battery cover. You can do this with a paperclip or something similar.

You may need to wipe out any dirt or debris that has built up.

Replace the gasket with the new gasket provided in your battery replacement kit.

This step is important for the collar to remain waterproof.

Insert the new battery’s wire plug into the collar connector, then place the battery inside the collar.

Put the front and back of the collar back together and hand-tighten the screws back into the collar with the provided screwdriver.

Be careful not to fasten the screws too tight as this can damage the collar.

After replacing the battery, you will need to pair your remote transmitter and collar. Please refer to HOW TO PAIR MY SPORTDOG® YARDTRAINER 350 REMOTE AND COLLAR.

If you need further assistance, please contact our customer care team.